Add hardware later?

[mbrodeur at nexttime.com (Matthew J. Brodeur)]

   Even the PNP model can be run in "Legacy ISA" mode by disabling PNP
with that utility.  IIRC there is also a batch file on the disk,
"pnpdsabl.bat" or something like that, that turns off the PNP switch
without running the full config GUI.

   I'm surprised that noone has mentioned just trying linuxconf (or 
just the netconf portion).  I've found that linuxconf does quite well for
setting up single interfaces, to the point of not having to edit anything
by hand.  For multiples of the same card I usually end up hand hacking
conf.modules to get them in the right order.


Matthew J. Brodeur, mbrodeur at NextTime.com
Hostmaster for NextTime.com
http://www.NextTime.com



On Mon, 10 Jul 2000, Bill Horne wrote:

> The 3C509 came in both ISA "Plug 'n Pray" and non PNP models; in 
> either case, the 3C5X9CFG.EXE file on 3Com's website will set 
> the units where you want them.
> 
> If you have the "Combo" model, with both BNC and RJ-45 
> connectors, be sure to option the correct interface.

-
Subcription/unsubscription/info requests: send e-mail with
"subscribe", "unsubscribe", or "info" on the first line of the
message body to discuss-request at blu.org (Subject line is ignored).