The Saga continues

Niall Kavanagh niall at kst.com
Sat Jan 6 01:56:49 EST 2001


On Fri, 5 Jan 2001, Nick Oleksinski wrote:

> Hi Again:
> Well, in my ongoing struggle to try & get my kernel to work with my
> ethernet card I built the kernel version 2.2.18 up from 2.2.13.  What's
> unfortunate is that my system won't boot now- it gives me the following
> message:
> 
> VFS: Cannot open root device 21:07
> kernel panic: VFS: Unable to mount root fs on 21:07
> 
> I assume this means that linux isn't recognizing my hard drive (Quantum
> Fireball KX27.4AT).  This drive supports Ultra-ATA 66 (66.4 Mbps burst)

What controller is the drive connected to? If it's the onboard IDE then
see if the other replies are helpful. If you're using an addon controller
you may need to tell lilo where to find it at the lilo prompt:

lilo: linux ide2=0xb400,0xb000,10 ide3=0xa800,0xa400,10

ide0/1 are the motherboard's interfaces (even if you've disabled them in
the BIOS), ide2/3 are the two channels on your first addon controller. If
you're only using one channel you don't need to specify the other.

The "10" would be the IRQ assigned to the controller, which shouldn't be
neccessary. To get the addresses:

a) boot with a rescue disk and take a peek at /proc/pci and look at the
addresses for the controller in there

... or ...

b) if you have windows installed, in the control panel click on the
"System" icon, then go to the "Devices" tab and look at the properties for
the controller. The addresses should be visible in there.

In any case, once you've got your system up, recompile a recent kernel
with proper support for whatever hardware you are using.

Good luck!

--
Niall Kavanagh, niall at kst.com
News, articles, and resources for web professionals and developers:
http://www.kst.com


-
Subcription/unsubscription/info requests: send e-mail with
"subscribe", "unsubscribe", or "info" on the first line of the
message body to discuss-request at blu.org (Subject line is ignored).



More information about the Discuss mailing list