Flashing a linksys router from Linux

[Jerry Feldman]

Thanks. Actually, flashing the box causes the settings to be messed up so 
the factory reset is a good thing to do.
"Matthew J. Brodeur" wrote:

> - - Log into the router's config page and clear the admin password.
> 
> - - From the linux box run: 
> $ tftp [router ip]
> > mode binary
> > put code.bin
>    You should see something like:
> Sent 649216 bytes in 30.6 seconds
> - - Exit the tftp client
> 
>   At this point I did a factory reset on the router.  It may or may not 
> be necessary, but I think the instructions suggest it.  Set the computer 
> to the right address for the factory configs (192.168.1.100 on mine), 
> connect to the router, and restore your settings.
> 
>    There is also a method to imbed the password in the tftp request, or to 
> patch tftp to authenticate properly.  I've found that clearing and 
> resetting the password is just easier.
-- 
Jerry Feldman <gaf at blu.org>
Boston Linux and Unix user group
http://www.blu.org PGP key id:C5061EA9
PGP Key fingerprint:053C 73EC 3AC1 5C44 3E14 9245 FB00 3ED5 C506 1EA9