IRQ

[linux_maitre at hotmail.com (Brad Noyes)]

I tried editting lilo.conf, but that didn't work. One the boot message 
i get "eth0" 3com 3c905b cyclone 100basetx at 0x1000, ff:ff:ff:ff:ff, 
irq 11". I put in the lilo.conf file ether=05. I would thing that it 
would put it at irq 5 but it didn't. I did run /sbin/lilo so it did 
take effect. The boot messages also say the it is setting eth0 to 
promiscuous mode. I'm still stuck, but i will still try to play with 
the lilo.conf

-Brad  

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
***
Subcription/unsubscription/info requests: send e-mail with
"subscribe", "unsubscribe", or "info" on the first line of the
message body to discuss-request at blu.org (Subject line is ignored).