 |
Home
| Calendar
| Mail Lists
| List Archives
| Desktop SIG
| Hardware Hacking SIG
Wiki | Flickr | PicasaWeb | Video | Maps & Directions | Installfests | Keysignings Linux Cafe | Meeting Notes | Linux Links | About BLU |
|
Home
| Calendar
| Mail Lists
| List Archives
| Desktop SIG
| Hardware Hacking SIG
Wiki | Flickr | PicasaWeb | Video | Maps & Directions | Installfests | Keysignings Linux Cafe | Meeting Notes | Linux Links | About BLU |
On 3 May 2000, at 14:07, Tewksbury, Chuck wrote:
> this begs a question... where you do you actually set the "Refresh Rate"?
>
> in the xf86config file?
In the Monitor section for your monitor. For example:
Identifier "A Monitor"
VendorName "Unknown"
ModelName "Unknown"
# HorizSync is in kHz unless units are specified.
<snip>
HorizSync 30-107
# VertRefresh is in Hz unless units are specified.
<snip>
VertRefresh 48-160
....
The XF86Config file is normally located in /etc/X11, but may be
elsewhere in some distributions.
Jerry Feldman <gaf at blu.org>
Associate Director
Boston Linux and Unix user group
http://www.blu.org
-
Subcription/unsubscription/info requests: send e-mail with
"subscribe", "unsubscribe", or "info" on the first line of the
message body to discuss-request at blu.org (Subject line is ignored).
