BLU Discuss list archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Converting single non-raid to raid1

Subject: Converting single non-raid to raid1
From: gaf-mNDKBlG2WHs at public.gmane.org (Jerry Feldman)
Date: Wed, 17 Feb 2010 13:05:36 -0500
In-reply-to: <20100217162056.GM32580-mzpnVDyJpH4k7aNtvndDlA@public.gmane.org>
References: <4B7C13EC.2050500@blu.org> <20100217162056.GM32580@tao.merseine.nu>

On 02/17/2010 11:20 AM, Dan Ritter wrote:
> They do not need to be the same geometry. If the interfaces are
> of grossly mismatching speed (say, USB2 vs PATA), you will run
> into frequent resynch issues.
>  =20
In this case they would both be SATA. But, possibly the speed of the
device, such as 7200RPM vs. 5400RPM. I would most likely chose the new
HD to be at the same speed as the one already installed.

--=20
Jerry Feldman <gaf-mNDKBlG2WHs at public.gmane.org>
Boston Linux and Unix
PGP key id: 537C5846
PGP Key fingerprint: 3D1B 8377 A3C0 A5F2 ECBB  CA3B 4607 4319 537C 5846

References:
- Converting single non-raid to raid1
  - From: gaf-mNDKBlG2WHs at public.gmane.org (Jerry Feldman)
- Converting single non-raid to raid1
  - From: dsr-mzpnVDyJpH4k7aNtvndDlA at public.gmane.org (Dan Ritter)

Prev by Date: Tips/advice for successful community funded (marketing) projects?
Next by Date: Converting single non-raid to raid1
Previous by thread: Converting single non-raid to raid1
Next by thread: Converting single non-raid to raid1
Index(es):
- Date
- Thread

Boston Linux & Unix / webmaster@blu.org