Abit BP6 system will not POST

[Owen B. Mehegan]

I knew about this problem when I first got the board, and performed the
necessary modification to work around it. I had to do it to my first BP6
board which I bought a year and a half ago, so I was prepared when I got the
second one :) The VTT voltage has been fine since I modified the board.

Also, in response to those who suggested I try a UPS, I've always used one
with this system, so I don't think power line conditions are the problem.

Last night I replaced the power supply with a known-good one, and still had
the same problems, so it looks like I've eliminated that factor as well.
Hopefully I'll have more time tonight to experiment. Thanks again everyone
:)

/owen

-----Original Message-----
From: discuss-admin at blu.org [mailto:discuss-admin at blu.org]On Behalf Of
David
Sent: Monday, February 25, 2002 7:14 PM
To: BLU
Subject: Re: Abit BP6 system will not POST


Owen,

Some BP6 boards (rev 1.1 ver 0.41) have a defective power capacitor (see
http://www.eecg.toronto.edu/~doylep/linux-bp6/). Also if you go into the
BIOS
( if you can get that far) see if the  the voltages are stable (VTT should
not fluctuate more than 0.35  -.5 V) . See
http://bp6.gamesquad.net/Q6fix.phtml for some information.

David
On Monday 25 February 2002 11:55, you wrote:
> A few days ago, I woke up and found my computer frozen. I reset it, and
the
> system would not come back up. The drives would spin, but the system did
> not beep and wouldn't POST. Eventually, I took out one CPU, and the box
> seemed to boot fine. Awhile later, however, it crashed again, and would
not
> reboot. After a few more tries, I got it to load and run the memory test,
> and then it failed again. Sometimes the system does not even POST. Other
> times it stops running/freezes after the memory test, during the OS
loading
> process, or in the BIOS settings menus - NEVER seen that happen before.
>
> So far, I have pulled one CPU, re-seated the video card, cleared the CMOS,
> and swapped/removed RAM from the system, all without success. Up until
now,
> the system has run fine, and I've made no recent changes to the hardware.
> The problem sounds like it could be heat, but even this morning, after the
> system had been off overnight, it would not even POST. Pertinent specs:
>
> Abit BP6 motherboard
> Dual Celeron 533 processors (not overclocked)
> 2x 256M Crucial PC 133 memory
>
> Any suggestions as to what could be causing this problem would be much
> appreciated. Thanks!
>
> /owen
>
> _______________________________________________
> Discuss mailing list
> Discuss at blu.org
> http://www.blu.org/mailman/listinfo/discuss

--
 .david
 David Lapointe
"A mind stretched to a new idea never returns to its original dimensions"
Oliver Wendell Holmes
_______________________________________________
Discuss mailing list
Discuss at blu.org
http://www.blu.org/mailman/listinfo/discuss