Freeswan - install - need help

[Derek Atkins]

Bob <gameslover987 at yahoo.com> writes:

> Hi,
> Another help need.
> I installed freeswan where I downloaded. I followed
> the instruction from freeswan and got the following
> errors:
> 
> 1. try to add pgp -ka freeswan-rpmsign.asc
> and got the error: pgp: command not found
> 
> 2. rpm --checksig freeswan*.rpm
> returns with error: could not exec pgp
> freeswan-modules-2.00_2.4.18...i386: pgp m5 not OK
> freeswan-userland-2.0_2.4.18...i386: pgp m5 not OK

Well, do you have PGP installed to verify the PGP Signatures?

> 3. ipsec verify:
> errors: Looking to forward for server 1 (NO KEY)
> Two or more interfaces failed. Checking IP Forwarding
> (FAILED)

Sounds like you did not configure it properly.  Perhaps you
don't have a key configured, or the name is incorrect, or you
didn't build a key, or....  There are lots of potential pitfalls.
The instructions are rather good if you read them from the
beginning to the end (admittedly it's hard to find the beginning).

> I use RedHat 7.3 with freeswan 2.4.18-3
> uname -r:   2.4.18-3
> 
> Thanks

If you continue to have problems, well, I can recommend a good
Security Consultant who can help you set it up (for a reasonable fee
;)

> Bob

-derek

-- 
       Derek Atkins
       Computer and Internet Security Consultant
       derek at ihtfp.com             www.ihtfp.com