[Discuss] New to VMWare DataStores

[Edward Ned Harvey (blu)]

> From: Discuss [mailto:discuss-bounces+blu=nedharvey.com at blu.org] On
> Behalf Of Scott Ehrlich
> 
> I am new to VMWare Datastores.   Previous positions have already had a
> vCenter system built and enterprise-storage ready.
> 
> We just installed a new Dell R520 PowerEdge server with 4 x 4 TB SAS
> drives, vCenter 5.5.0 preinstalled, and a 2 TB boot disk.
> 
> Do we need to create a PERC RAID set with the 4 TB disks for vCenter
> to see that volume as a Datastore?
> 
> I've been googling to see what is fundamentally needed for disks to be
> visible in vCenter for a Datastore to be created.

Oh dear.  You're not going to like this answer.

First of all, if you're installing on a Dell, you should ensure you've checked Dell's site to see if you need the Dell customized installation image.
            Go to http://support.dell.com
            Enter your service tag
            Go to Drivers & Downloads
            For OS, select VMWare ESXi 5.1 (or whatever is latest)
            If you see "Enterprise Solutions" with "ESXi Recovery Image" under it, you need to use that custom ISO.
        Otherwise, go to vmware.com and download the standard VMWare ESXi ISO

Before you begin, you probably want to configure your PERC as one big raid set.  Vmware doesn't have support for storage changes, soft raid, changes to hard raid, snapshots, or backups.  It can handle raw disks, iscsi, nfs, and not much else.  It also doesn't support backups unless you pay for some thing (not sure what, and not sure how much.)  With a Dell server specifically, you can contact Dell about how to install OMSA, which will give you an interface you can use to control your PERC configuration without needing to reboot the system, but the extent of usefulness will be limited to basically replacing failed disks without the need for rebooting.  Just make sure you don't upgrade vmware after you've installed OMSA (or else you have to reinstall OMSA).

By far, far, far, the best thing to do is to run vmware on a system that is either diskless or has a minimal amount of disk that you don't care about, just for vmware.  My preference is to let the vmware be diskless, and let the storage system handle all the storage, including the vmware boot disk.  (Generally speaking, it's easy to boot from iscsi nowadays, so there's no need to muck around with pxe or anything annoying.)  Let the guest machine storage reside on something like a ZFS or other storage device that's meant to handle storage well, including snapshots & backups.  Solves *all* the problems.  Using simple dumb 10G ether works well and inexpensively as long as you get sufficient performance out of it (it performs equivalently to approx 6 or 9 disks).  Anything higher performance will need infiniband, fiber channel, or similar.

By far, my favorite setup is a ZFS server for storage, and a diskless ESX server to do work.