[HH] conductive 3d printer filament

[Drew Van Zandt]

I could design with that as long as everything was slow.  I'd assume you
would try to print directly over components, or something like that.



*Drew Van Zandt Cam # US2010035593 (M:Agapito Acosta) *


On Thu, May 22, 2014 at 10:56 AM, Jon Evans <jon at craftyjon.com> wrote:

> 10k Ohms per cm?  Sounds like it would be more useful for ESD shielding
> than drawing circuit traces, although I guess it depends on the circuit...
>
>
> On Thu, May 22, 2014 at 10:41 AM, Greg London <email at greglondon.com>wrote:
>
>> I just discovered this.
>>
>> conductive filament for 3d printers.
>> "print your own circuit boards"
>>
>> http://www.makergeeks.com/co3dfi.html
>>
>> Cool idea, but if you use heat to melt the filament,
>> I'm not sure how you can solder parts to it.
>>
>> conductive glue?
>>
>> _______________________________________________
>> Hardwarehacking mailing list
>> Hardwarehacking at blu.org
>> http://lists.blu.org/mailman/listinfo/hardwarehacking
>>
>
>
> _______________________________________________
> Hardwarehacking mailing list
> Hardwarehacking at blu.org
> http://lists.blu.org/mailman/listinfo/hardwarehacking
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.blu.org/pipermail/hardwarehacking/attachments/20140522/c70ed69f/attachment.html>