[HH] conductive 3d printer filament

[Greg London]

10k Ohms per cm? I didn't notice that. Not good.

Actually, a friend just asked a very good question:
Why not use *solder* as the conductive filament?


> I could design with that as long as everything was slow.  I'd assume you
> would try to print directly over components, or something like that.
>
>
>
> *Drew Van Zandt Cam # US2010035593 (M:Agapito Acosta) *
>
>
> On Thu, May 22, 2014 at 10:56 AM, Jon Evans <jon at craftyjon.com> wrote:
>
>> 10k Ohms per cm?  Sounds like it would be more useful for ESD shielding
>> than drawing circuit traces, although I guess it depends on the
>> circuit...
>>
>>
>> On Thu, May 22, 2014 at 10:41 AM, Greg London
>> <email at greglondon.com>wrote:
>>
>>> I just discovered this.
>>>
>>> conductive filament for 3d printers.
>>> "print your own circuit boards"
>>>
>>> http://www.makergeeks.com/co3dfi.html
>>>
>>> Cool idea, but if you use heat to melt the filament,
>>> I'm not sure how you can solder parts to it.
>>>
>>> conductive glue?
>>>
>>> _______________________________________________
>>> Hardwarehacking mailing list
>>> Hardwarehacking at blu.org
>>> http://lists.blu.org/mailman/listinfo/hardwarehacking
>>>
>>
>>
>> _______________________________________________
>> Hardwarehacking mailing list
>> Hardwarehacking at blu.org
>> http://lists.blu.org/mailman/listinfo/hardwarehacking
>>
>>
>


--